A sturdy stand for a phone or a tablet, upright or sideways. The back support plugs into one of three pairs of sockets for about 55, 65 or 75 degrees, the lip holds a device in a case up to 15 mm thick, and a slot through the lip lets you charge while it stands. The deep foot keeps even a 13-inch tablet steady. Two parts, no screws, no supports.
Free for personal use under CC BY-NC 4.0: print it, remix it and share it with credit to Shapekit. Please don't sell the files or the prints.
Every part as you print it. Pick colours to see what your filament will look like.
Drag to rotate · scroll or pinch to zoom
Every STL is already placed the right way up. Download them all at once, or one by one.
The foot with the lip, a slot for the charging plug, three pairs of sockets marked 75°, 65° and 55°, a groove underneath that takes the cable to the back, and recesses for four rubber feet.
Plugs into the base with two prongs; small ribs in the sockets hold it without wobbling. The device leans on its rounded top edge.
For a 0.4 mm nozzle. Filament amounts are estimates for these settings.
Both parts print flat without supports. Give the base 4 walls and 25% infill: at about 200 g it stays put when you tap a 13-inch tablet.
Optional: press four rubber bumpers into the round recesses under the base, so the stand doesn't slide.
Push the prongs of the back support into one pair of sockets until it sits on the base: 75° at the front is the most upright, 55° at the back the flattest.
The first time, push firmly. Small ribs in the sockets squash a little and then hold the support without play.
Put your phone or tablet on the ledge behind the lip, screen forward, and lean it back against the support. A thick case makes it stand up to 3 degrees steeper. A 13-inch tablet standing upright (portrait) is steadiest at 65 or 75 degrees.
Put the cable through the slot in the lip and plug it in, let it bend down behind the lip and lead it back through the groove under the base.
A working desk fan shaped like a car turbocharger, with a speed knob in the base.
View and download
A turbofan with 20 swept blades. Fits the Turbo Desk Fan's base and prints without supports.
View and download
A fluted planter for a 12 cm plant, with a hidden 0.6 litre reservoir and a float that shows the water level.
View and download
A sturdy headphone stand with a bayonet base, a cushioned hanger, an earbud tray and a cable hook.
View and download
Two small drawers and a wide one, with drawer stops and clip-on handles. Stack or link as many as you like.
View and download
A hanging seed feeder with a twist-lock tube, a perch ring and a roof that slides up to refill.
View and download
Pen cups, a scissor slot and a tray on a base that spins smoothly on 6 mm airsoft BBs.
View and download
A hand-cranked 5:1 planetary gearbox with herringbone teeth. Clicks together and prints without supports.
View and download
Lifts your screen about 12 cm at a 20° tilt. Fits 11 to 16 inch laptops; the cross bars wedge in, no screws.
View and download
Rolls any spool from 250 g to 3 kg on four 608 skate bearings, with a filament guide. Any hub size.
View and download
Put your own photo in a phone case, lamp shade or lithophane, right in your browser.
Open the makers