SKADIS-compatible pegboard accessories - free 3D models from Shapekit
https://shapekit.cc/skadis-pegboard

Twelve parts that hang in the 5 x 15 mm slots of an IKEA SKADIS pegboard, or of the board you can make in your own
size on the page above. SKADIS is a trademark of Inter IKEA Systems B.V.; these parts are not made or endorsed by IKEA.

Hanging a part: push its tabs into the slots at the top, then let it drop about 5 mm. The tab rests on the bottom of
the slot and the leg behind it holds the part against the board. To take it off, lift it and pull it out.

Printing: every STL is already placed the right way for printing, without supports. The hooks lie on their side,
the parts with two or more tabs print upside down (top face on the bed), the bin, the cup and the tape rod stand up.
0.2 mm layers, 3 walls, 15 % infill, PLA or PETG. Turn on elephant's foot compensation (about 0.15 mm).

Parts

- Small hook: Keys, scissors, a cable or a dust pan. One slot. Files: skadis-pegboard-small-hook.stl.
- Long hook: 80 mm long and rising a little, for cable coils, a tape measure, bags and tools with a hanging hole. Files: skadis-pegboard-long-hook.stl.
- Cable and headphone hook: A deep U for an extension cord, coiled cables or headphones. Files: skadis-pegboard-cable-hook.stl.
- Shelf: 120 × 90 mm with a raised front edge and three brackets: spray cans, glue, a small speaker. Files: skadis-pegboard-shelf.stl.
- Bin with holder: A 65 × 50 × 60 mm bin that lifts out of its holder, so you can take the screws with you. Files: skadis-pegboard-bin-holder.stl, skadis-pegboard-bin.stl.
- Cup with holder: A round Ø60 × 90 mm cup that lifts out: pens, brushes, pliers, a spray can. Files: skadis-pegboard-cup-holder.stl, skadis-pegboard-cup.stl.
- Screwdriver rack: Five screwdrivers, shaft down, with holes from 6.5 to 10.5 mm and room between the handles. Files: skadis-pegboard-screwdriver-rack.stl.
- Pliers rack: Four pliers or side cutters hang by their joint between the prongs. Files: skadis-pegboard-pliers-rack.stl.
- Bit holder: Fourteen 1/4" hex screwdriver bits in two rows. Files: skadis-pegboard-bit-holder.stl.
- Hex key holder: Metric Allen keys from 1.5 to 10 mm, each hole with its size on top. Files: skadis-pegboard-hex-key-holder.stl.
- Cable organizer: Five charging cables click into the slots; the plugs rest on top. Files: skadis-pegboard-cable-organizer.stl.
- Tape holder: A rod for tape rolls, from insulating tape up to two rolls of duct tape. Files: skadis-pegboard-tape-holder.stl, skadis-pegboard-tape-rod.stl.

License: CC BY-NC 4.0 (free for personal use, credit Shapekit, not for sale).